team ywach stomps and that rhymes. uq holder team only have mountain level scaling from touta konoe with mhs combat speed which ywach team are far above being relativistic and all.
the flood vs necromorphs a necromorph is by cutting em up while flood can be killed by conventional means sure they can be revived if the corpse didnt get fucked to badly but i doubt it seeing
conventional solution for this . what is worse at the place where network is not stable speed is drastically decreased. fft (fast file transfer) solves these problems with cutting-edge
conventional versus high speed machining: conventional machining differs greatly from hsm in a lot of aspects. when using conventional machining techniques the contact time between the tool and piece is much greater than it is with hsm. conventional machining also involves a much greater cutting force.
during conventional milling the cutter tends to dig into the workpiece and may cause the part to be cut out of tolerance. however though climb milling is the preferred way to machine parts there are times when conventional milling is the necessary milling style. one such example is if your machine does not counteract backlash.
tools wear faster than with climb milling. conventional milling is preferred for rough surfaces. tool deflection during conventional milling will tend to be parallel to the cut (see the section on tool deflection for more). advantages of climb milling (down milling): the width of the chip starts at maximum and decreases.
leo-343: your argument can only be valid if saitama has actually shown any vulnerability to cutting attacks which hasn't been shown. your whole argument is based off the speculation at this point.